[linrad] Re: Linrad-02.04

[Leif Asbrink <sm5bsz.com; leif@xxxxxxxxxxxxxxxx>]

Hi Ramiro,

> I have just downloaded Linrad-02.05 and I can go a little bit further 
> but It crashes again. This is the sequence of commands
> 
> 
> I press "S"
> I choose "1" font size.
> I choose "N" to allow swapping.
> 
> I press "A"  for weak signal CW
> I choose device 63     /dev/dsp
> I choose RDRW   "W"
> I choose "one RX channel"
> I choose 44100 sampling rate
> "close and reopen"? ----> "YES"
> I press a key to return to the main menu.
> I press "w" to save setup
> I press "A" for weak signal CW.
> I enter into the parameter selection screen
> I press "Enter"
> I press "Enter"
> I press "Enter"
> I press "Enter"
> 
> It bombs out:
> "segmentation fault"
Could be CPU overload. Try to deselect fft2 and also
set baseband storage time low. Remove par_wcw first
because otherwise you may not be able to reach the
parameter setting screens. (or edit par_wcw manually)


73

Leif / SM5BSZ


#############################################################
This message is sent to you because you are subscribed to
  the mailing list <linrad@xxxxxxxxxxxxxxxxxxxxx>.
To unsubscribe, E-mail to: <linrad-off@xxxxxxxxxxxxxxxxxxxxx>
To switch to the DIGEST mode, E-mail to <linrad-digest@xxxxxxxxxxxxxxxxxxxxx>
To switch to the INDEX mode, E-mail to <linrad-index@xxxxxxxxxxxxxxxxxxxxx>
Send administrative queries to  <linrad-request@xxxxxxxxxxxxxxxxxxxxx>


LINRADDARNIL