[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[linrad] Re: Linrad-02.04



Hello Leif and linraders!




Thank you very much for your efforts in building an X-window based version off Linrad. I think it is a good thing in order to improve Linrad compatibility between systems. It is great to have the oportunity to choose X or svgalib (good for old hardware)

I have just installed Linrad-02.04 under Debian GNU/Linux Sarge.

I run the folowing commands:

$./xlinrad

I press "S"
I choose "1" font size.
I press "A"  for weak signal CW
I choose device 63     /dev/dsp
I choose RDRW   "W"
I choose "one RX channel"
I choose 44100 sampling rate
"close and reopen"? ----> "YES"


It bombs out:
"segmentation fault"

And X-window window closes.

I have just downloaded Linrad-02.05 and I can go a little bit further but It crashes again. This is the sequence of commands


I press "S"
I choose "1" font size.
I choose "N" to allow swapping.

I press "A"  for weak signal CW
I choose device 63     /dev/dsp
I choose RDRW   "W"
I choose "one RX channel"
I choose 44100 sampling rate
"close and reopen"? ----> "YES"
I press a key to return to the main menu.
I press "w" to save setup
I press "A" for weak signal CW.
I enter into the parameter selection screen
I press "Enter"
I press "Enter"
I press "Enter"
I press "Enter"

It bombs out:
"segmentation fault"

And X-window window closes.

I run standard Debian sarge with standard stock 2.6.8 kernel.

Thak you very much

Ramiro.





#############################################################
This message is sent to you because you are subscribed to
 the mailing list <linrad@xxxxxxxxxxxxxxxxxxxxx>.
To unsubscribe, E-mail to: <linrad-off@xxxxxxxxxxxxxxxxxxxxx>
To switch to the DIGEST mode, E-mail to <linrad-digest@xxxxxxxxxxxxxxxxxxxxx>
To switch to the INDEX mode, E-mail to <linrad-index@xxxxxxxxxxxxxxxxxxxxx>
Send administrative queries to  <linrad-request@xxxxxxxxxxxxxxxxxxxxx>

LINRADDARNIL