The only other thing running should be the KDE desktop.
Hmmm, could
be many things in it. I always run from a terminal,
KDE does not run well
on my smaller computers because it becomes
extremely slow due to all
swapping it does....
My idle times are as follows:
.0078
.0086
.0459 [122]
.0481
.0537
.105
.2174 [122]
.3825 [122]
.4030 [122]
.4266 [122]
Ooooh!!! =.4
seconds. Far from real time processing;-)
I think KDE must be
doing something it thinks you want done.
Could also be
something with networks or whatever.
Very unlikely that
this problem has anything to do with
Linrad
itself.
Z reset
.0077
.0078
.0987 [122]
.0358 [122]
.0618
.3489 [122]
As you can see 8
milliseconds is fine but 45 milliseconds is too much.
Leif when not doing a "Z" I clear the error by left clicking the
edge of the main display. I don't think I sould be using this reflector for
this. Shall I email you direct if so what address should I use?
I think this is of
general interest. I can not really help because I do not know how to find out
what is going on and how to remove things that are scheduled to happen
now and then in the background.
You could turn off the
swapp and see what happens - something might
complain..........
If you want to stay
under KDE, maybe someone else on this list knows how to make sure
Linrad never looses more than
about 20 milliseconds in a single interruption and that
Linrad
will always get at
least a few milliseconds between each interruption so it has time
complete
it's slowest single
task and take cate of the A/D and D/A buffers.
73
Leif /
SM5BSZ