[linrad] Linrad01-12

[Leif Åsbrink <leif.asbrink@xxxxxxxxxxxxxxxxxxxx]

Hi all,

After upgrading from a 600MHz PIII to a 2.6GHz PIV I
found some problems with Linrad.

1) The serial interface to the WSE converters was intended
to have a timing from the system clock. A simple bug caused
this to not function, causing timing ti be determined by
processor speed. Did not work on the PIV;)
Now corrected.

2) When receiving large bandwidth (SSB/AM/FM) the 
update rate for graphs becomes the limiting factor.
00-12 has slightly more efficient graphics that update
the screen less frequently. An AM station at 6 kHz
bandwidth that used 90% of the available CPU resources
on Linrad01-11 now uses about 10% of the CPU time.

3) When running Linrad on a computer with small memory,
the error messages indicating no more memory available 
do not work in old Linrad versions if the swap file is
enabled. The Linux kernel just allocates memory on the hard 
disk. Linrad-01.12 uses memory locking to ensure Linrad and
it's data will not be swapped. If locking fails an "out of 
memory" will tell the operator to select less demanding 
parameters.


Bug reports are welcome.


  73

 Leif / SM5BSZ



LINRADDARNIL