[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [linrad] IC706MKIIG
- Subject: RE: [linrad] IC706MKIIG
- From: Leif Åsbrink <leif.asbrink@xxxxxxxxxxxxxxxxxxxx
- Date: Tue, 9 Dec 2003 22:55:55 +0100
Hi Jim,
> The 706 series is very picky about low power supply voltage.
> I had to run #4 welding wire from my battery so I could run mobil
> with the engine off. Somewhere near +12 volts and the frequency
> becomes unstable. If your power source spikes momentarily below
> 12 volts, it is very likely to cause a problem. This may or may not
> relate to your problem, but is something to check. Some shortcuts
> were taken in the 706 design, especially the noise blanker.
OK. I do not think I have any problem here. I have a good 10A
supply. I can not run at full power, but the problems are not
changing when I change the output power. On 144 MHz the keying is
perfect at all power levels.
It seems the ALC (=driver stage gain) is not something the user is
supposed to adjust. I have also received comments saying that this
radio is known to be problematic on CW.
When set for full break-in it causes terrible keying clicks. This
mode should never be used in IC706MKIIG.
73
Leif
LINRADDARNIL