FW: Internal Error 1040 with linrad and SuSE 7.3 (e Oct 12 2002)

[Leif Åsbrink <leif.asbrink@xxxxxxxxxxxxxxxxxxxx]

-----Original Message-----
From: owner-linrad@xxxxxxxxxxxxxxxxxxxxx
[mailto:owner-linrad@xxxxxxxxxxxxxxxxxxxxx]On Behalf Of e
Sent: Saturday, October 12, 2002 9:32 PM
To: linrad@xxxxxxxxxxxxxxxxxxxxx
Subject: [linrad] Internal Error 1040 with linrad and SuSE 7.3


Hello,

when starting the hardware test mode under linrad 4.7, there were two device
drivers listed:
under dev/dsp and dev/dsp0.
after selecting one of them and then selectiong the read or read and write
mode and then selecting the normal rx-mode or other modes i get always an
error code:

INTERNAL ERROR: 1040 (errno 22)
routine:set_analog_io    file setad.c
call to ioctl failed. (SNDCTL_DSP_SPEED)

I am using an soundblaster ISA PnP AWE 64 and ALSA with SuSE 7.3.


Thanks in advance for any information!

ernst, dl2lac




LINRADDARNIL