Re: [linrad] For general interest

["Pierre Vanhoucke" <pierre.vanhoucke@xxxxxxxxxxxxx]

Hello Ron,

An  answer to your  question can be found in the book 'Experimental methods
in RF DESIGN' ( published by the ARRL ) in chapter 9.6 (page 9.24 to 9.27).

73,
Pierre/ON5GN

----- Original Message -----
From: "W6WO" <ron-skelton@xxxxxxxxxxx>
To: <linrad@xxxxxxxxxxxxxxxxxxxxxx>
Sent: Monday, August 18, 2003 9:27 PM
Subject: [linrad] For general interest


> Here are a few sites that might be useful
>
> For comparing sound cards
> http://www.pcavtech.com/soundcards/compare/
> http://www.tracertek.com/comparisonchart.htm
>
> The Skyworks SKY73001-11 (http://www.skyworksinc.com/) is an
> interesting device designed specifically for direct conversion I-Q
> receivers. Brief specs are
> RF 2 -3500 MHz
> IF 0 -100 MHz
> IIP3 +26 dBm
> IIP2 +67 dBm
>
> I have been looking at the noise specifications of  various DC
> regulators which could affect base-band noise levels, there is a wide
> range.  In summary
>
> At the high end the LM 317 and 337 series have RMS noise levels of
> 0.003% of Vout. The spec states this is over 10 Hz to 10 KHz
>
> The best I could find from Motorola was the MC1723C that seems to
> have very low noise (2.5 uV) this is stated over the range 100 Hz to
> 10 kHz
>
> The MC78L/79L 100 m/A series have noise levels  5V/40 uVrms, 12V/75
> uVrms, 15V/90 uVrms stated to be  in the 10-100 kHz range.
>
> It is reasonable to expect these levels could be reduced by Tantalum
> capacitors at the device output but it seems smart to select low
> noise devices to begin with.
>
> For further immunity the spec for the AD797 amplifier recommends 0.1
> uF and 4.7uF capacitors at the + and - supply pins with <5 mm leads
> to ground.
>
> Now a question.
> In most I-Q demod designs I note the phase shift is applied to the
> LO.  In the simple 40 kHz 2x SBL-1 design that Leif published in QEX
> the shift is applied to the RF. What is the reason for this approach ?
>
>
>
> --
> 73
> Ron
> W6WO
>



LINRADDARNIL