[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [linrad] audio channels
- Subject: Re: [linrad] audio channels
- From: "Rein A. Smit" <rein0zn@xxxxxxxxxxxxxxxxx
- Date: Wed, 21 May 2003 15:31:24 -0700
Arie,
OK, you are right on the output part. The stereo card should
have 2 channels all the way through. It is a requirement for
playing stereo .wav files It should work with one card in
that case.
In case of the delta44 though I assume that card should also
have 4 output channels so to say. having a second card for
playing the audio provides freedom in selecting sampling freq's
In my case with the AC97, Linrad reports 2 channels.
Though in reporting it does not report the 2 as the same.
Are you able to play stereo on you laptop?
73 Rein
Arie Dogterom wrote:
>
> Hallo Rein,
> As I now understand the I and Q channels can be handled by the left and
> right channels of the stereo input of one card. I do not see why then a
> second card would be required. The D-A convertor of the card is separate
> from the A-D convertor although they in general use the same clock.
> You only need more cards if you need more than 2 channels.
> I am still wondering why Linrad reports about my card that there are 4
> channels. I, anyhow, cannot acces more than one on my laptop. But the chips
> probably have internally on th MB unused inputs.
> 73
> Arie
>
> ----- Original Message -----
> From: Rein A. Smit <rein0zn@xxxxxxxxxxxxx>
> To: <linrad@xxxxxxxxxxxxxxxxxxxxxx>
> Sent: Wednesday, May 21, 2003 11:34 PM
> Subject: Re: [linrad] audio channels
>
> >
> > Hi Arie,
> >
> > It depends on whether you have 1 or 2 mixers. With one mixer you
> > can go with one stereo sound card plus another card for audio output.
> >
> > With a dual antenna, as for polarity systems, you need 4 audio
> > inputs and for a number of other good reasons, you might as well
> > go DELTA 44 sound board with 4 inputs plus another card for audio
> > output also stereo.
> >
> > You could however use 2 regular stereo cards for the front end and
> > an additional stereo card for audio output. The max sample freq of
> > the
> > audio card and ADC resolution effect the max freq band you can
> > monitor and dynamic range etc.
> > I believe either Leif or Roger had that at one time and Linrad is
> > able to work with these 3 cards.
> > You like, probably, the front end cards to sample at a much higher
> > rate then the audio output card.
> > I believe the DELTA44 card is still up to this point the best
> > solution -for the cost/performance ratio.
> > You will have to work through Leif's and Roger's pages to
> > see the relations between bandwidth and performance of the receiver.
> > There are 2 QEX ( ARRL ) papers and they are on the net. The papers
> > cover in great detail the different combinations. ( Not quite sure
> > whether it needs ARRL membership access ot not ) If you can't
> > get it, there are ways.
> > This is at least, the way I understand it.
> >
> > Regards
> >
> > Rein
> >
> > Arie Dogterom wrote:
> > >
> > > Hello,
> > > My question probably has been answered in some of the texts, but I a
> still
> > > unsure :
> > >
> > > Having the mixers with the I an Q outputs, where shall those go : Does
> one
> > > need two soundcards or is it possible to use the left and right channels
> of
> > > a stereo card?
> > > 73
> > > Arie
> >
LINRADDARNIL