Re: Linrad 02-41


Hi, Stan et al,

I just fired things up to check it out here.

On Windows XP the stock download of Linrad-02.41 runs OK and controls 
the WSE OK with no strangeness.

I am using it on a Core 2 Duo machine running the 32 bit form of XP, 
and my parport has address 33792 [0x8400].

I of course have inpout32 installed as well, to permit parallel port control.

I suspect that there was a problem with your compile, even though you 
get no error message.  Why not use the precompiled version of 02.41?  
I'll bet it runs fine!

http://www.sm5bsz.com/linuxdsp/archive/wlr2-41.zip

Will get it for you, and I suspect there will be no problems if you use it.

Also, would suggest starting in an empty directory...

73,

W3SZ
Roger Rehr
http://www.nitehawk.com/w3sz


Quoting hihi
>
>
>
> I tried exiting and reentering the program. The results are the same. 
> I have no control of WSE hardware.
>
>
> -----Original Message-----
> From: Leif Asbrink <Thu, 17 Jan 2008 8:09 pm
> Subject: Re: Linrad 02-41
>
>
>
>
>
> Hi Again Stan,
>
> Maybe, if you start Linrad and run through the
> general parameters setup (screen, parport etc.) you
> would have to exit and restart Linrad to make your
> choices valid. Please try that and tell me if it works.
> Maybe I have to force an exit after running 'S'=Global.....
>
> 73
>
> Leif / SM5BSZ
>
>
>> I was unable to get 02-41 working with my WSE hardware. It uses
>> Parport 888 and Ack=10
>> I try to do Z=Hardware Test and the Linrad program shuts down.
>>
>> This same computer works fine with Linrad 02-35
>>
>> Stan, KA1ZE/3
>> >
>
>
>
>
> ________________________________________________________________________
> More new features than ever.  Check out the new AOL Mail ! - 
> http://webmail.aol.com
>
> >
>


Roger Rehr
W3SZ
http://www.nitehawk.com/w3sz