[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Linrad] Re: Polswitching from H / V Antenna
- Subject: [Linrad] Re: Polswitching from H / V Antenna
- From: Leif Asbrink <sm5bsz.com; leif@xxxxxxxxxxxxxxxx>
- Date: Wed, 4 Nov 2009 22:45:50 +0100
Hi Carsten,
> > Besides having the correct signal level into MAP65 you must also
> what is the right level ?
I do not remember. It is written somewhere in the MAP65 documentation.
> > you must also have the correct time
> The time in Linrad is the same as in MAP65 - same PC - .
> - sync by Dimension 4
Well, I have no experience with that. I would verify by checking
dt from MAP65;-)
> What is the way to calibrate the WSE and the filters ?
> What level the WSE need for calibrate ?
The unit that needs calibration is the RX2500. For I/Q balancing
it does not matter if you send the signal into 2.5, 10.7, 70 or
144 MHz. Use what is convenient - but connect both channels.
For the filter calibration, send pulses into the 10.7 MHz inputs.
The frequency response is a little affected by the feed impedance
into the RX2500 because it uses noiseless feedback and that
means that the input impedance to the 2.5 MHz filter will
be a little affected.
Read the section about calibration on the Linrad Home Page:
http://www.sm5bsz.com/linuxdsp/linrad.htm
And follow the links there.
73
Leif
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups "Linrad" group.
To post to this group, send email to linrad@xxxxxxxxxxxxxxxx
To unsubscribe from this group, send email to linrad+unsubscribe@xxxxxxxxxxxxxxxx
For more options, visit this group at http://groups.google.com/group/linrad?hl=en
-~----------~----~----~----~------~----~------~--~---
LINRADDARNIL