[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Linrad] Re: Linrad and MAP65IQ not working



Title: Message
Hi Jeff. I see the same problem here but only when running Map65 on a different computer than Linrad.  With Map65 running on the same computer that never happens.  But when I send the output to a different ip address and run Map65 there, quite often I see the same problem you observe.  However if I restart Map65 several times (maybe 3 - 5 times on average) then it will suddenly start working and then never fails after that.  I did mention this to Joe on Monday.
 
I have been working on other problems since then so have not looked into this further, but one thing I suspect is that it may relate to what part of the minute I start map65 in.  If I start it late in the minute then it does not attempt to decode at the end of that minute, but then at the end of the next minute is when it freezes.  I have not carefully tested to see if the successful start is when I start Map65 near the beginning of a minute, but I am wondering if that could be the case.
 
Again, this does not happen when I run both Linrad and Map65 on same computer.  I'm running them on a Dell laptop with about 1.6 GHz processor and 2 gigs of ram.  An earlier attempt to do it with only 500 mb of ram failed miserably, so make sure you have lots of memory.
 
Hope this helps,
73, Russ K2TXB
 


From: linrad@xxxxxxxxxxxxxxxx [mailto:linrad@xxxxxxxxxxxxxxxx] On Behalf Of K7XQ
Sent: Wednesday, October 21, 2009 3:24 AM
To: linrad@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx: [Linrad] Linrad and MAP65IQ not working

Hello All,
I am new to the group and joined because I just spent the last two weeks trying to get Linrad and MAP65 to work with no success.
 
I am able to get Linrad and Winrad working very nicely however.
 
The problem is that when MAP65IQ tries to decode the first sequence of data, the clock freezes on MAP65 and there are no decode but the MAP65
waterfall continues to function along with the waterfalls clock. I tried for days trying all kinds of Linrad configurations with no luck.
 
The hardware is a brand new RF Space SDR-IQ receiver and 2.7 GHz computer with 2 gigs of Ram.
 
K7XQ Jeff
Atwater,CA.
K7XQ logbook and webpage: 
http://www.elite.net/~k7xq/k7xq.html
 
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups "Linrad" group.
To post to this group, send email to linrad@xxxxxxxxxxxxxxxx
To unsubscribe from this group, send email to linrad+unsubscribe@xxxxxxxxxxxxxxxx
For more options, visit this group at http://groups.google.com/group/linrad?hl=en
-~----------~----~----~----~------~----~------~--~---

LINRADDARNIL