[Linrad] Re: Linrad 305 frequency

[Dave-W5UN <wt.net; w5un@xxxxxxxxxxxxxxxx>]

Hi Leif,

ParPort 888:10 is not showing, but I have set linrad up for ParPort
888:10. How do I turn it on so that it shows in the top startup line?

On Apr 20, 7:58 am, Leif Asbrink <l...@xxxxxxxxxx> wrote:
> Hi Dave,
>
> > When I inject a 144.130 mHz carrier signal (-125 dbm) into the wse
> > converters, the signal shows up on the linrad 305b waterfall at
> > 144.115 mHz, and there is nothing at 144.130. Is this a bug? On
> > earlier versions of linrad the signal shows up at the correct
> > frequency.
>
> This seems odd. Did you verify that an old version still
> shows the signal at the expected frequency?
>
> It seems more likely to me that the signal generator is off
> frequency that that the wse units are.
>
> Do you have the message "Parport 888:10" or similar in red on
> the top line of the main menu? If Linrad is not set up for
> a parallel port it will not try to set the WSE frequencies and
> then all sorts of odd phenomena may occur since more than one
> crystal may be active at the same time in a single oscillator.
>
> 73
>
> Leif / SM5BSZ

--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups "Linrad" group.
To post to this group, send email to linrad@xxxxxxxxxxxxxxxx
To unsubscribe from this group, send email to linrad+unsubscribe@xxxxxxxxxxxxxxxx
For more options, visit this group at http://groups.google.com/group/linrad?hl=en
-~----------~----~----~----~------~----~------~--~---


LINRADDARNIL