[linrad] Linrad 02.05

[Ramiro Aceves <gmail.com; ea1abz@xxxxxxxxxxxxxxxx>]

Hello again.

I have tested xLinrad 02.05 on both very different machines. A 1.86 GHz 
1GB RAM Pentium Centrino laptop and a 1.2 GHz AMD Athlon 256 MB desktop 
computer. I get an strange CPU usage increase up to 100 % before real 
operation, in the parameter selection screen.



************   xlinrad   *************
***  Both computers, same result.  ***



I press "S"
I choose "1" font size.
I choose "N" to allow swapping.

I press "A"  for weak signal CW
I choose device 63     /dev/dsp
I choose RDRW   "W"
I choose "one RX channel"
I choose 44100 sampling rate
"close and reopen"? ----> "YES"
I press a key to return to the main menu.
I press "w" to save setup
I press "A" for weak signal CW.
I enter into the parameter selection screen


At this point the CPU usage goes up to 100%!!! The laptop fan starts 
going fast!




top - 12:43:15 up  1:14,  3 users,  load average: 0.93, 0.44, 0.17
Tasks:  80 total,   1 running,  78 sleeping,   0 stopped,   1 zombie
Cpu(s): 99.7% us,  0.3% sy,  0.0% ni,  0.0% id,  0.0% wa,  0.0% hi,  0.0% si
Mem:   1028320k total,   385420k used,   642900k free,    28092k buffers
Swap:   489972k total,        0k used,   489972k free,   174272k cached




I press "Enter"
I press "Enter"
I press "Enter"
I press "Enter"

It bombs out:
"segmentation fault"

****************************************

Thank you very much.
Ramiro, EA1ABZ.

#############################################################
This message is sent to you because you are subscribed to
 the mailing list <linrad@xxxxxxxxxxxxxxxxxxxxx>.
To unsubscribe, E-mail to: <linrad-off@xxxxxxxxxxxxxxxxxxxxx>
To switch to the DIGEST mode, E-mail to <linrad-digest@xxxxxxxxxxxxxxxxxxxxx>
To switch to the INDEX mode, E-mail to <linrad-index@xxxxxxxxxxxxxxxxxxxxx>
Send administrative queries to  <linrad-request@xxxxxxxxxxxxxxxxxxxxx>


LINRADDARNIL