[linrad] Re: Linrad-02.05

[w3sz <comcast.net; w3sz@xxxxxxxxxxxxxxxx>]

Hi, Leif,

Just a quick final note before I run off to work:

THe previous note of course referred to xLinrad, as does this one.

I went back to xLinrad and found that:
1st FFT storage time was 1 second.  I left it there
2nd FFT storage time was 5 seconds.  I left it there
Baseband storage time was 200 seconds.  I changed it to 9 seconds.

I turned off AFC/Spur rejection.

Other parameters were all left at the defaults set by xLinrad when it  
installed.

After the above, moving the mouse across the screen when in receive mode  
again caused xLinrad to crash.

I hope the above helps.

I don't know if my system is using MMX routines.  Does anyone know an easy  
way to check this?

Linrad 02.05 under svgalib continues to work ok here.

73,

Roger
W3SZ


--
Roger Rehr
W3SZ
http://www.nitehawk.com/w3sz/

#############################################################
This message is sent to you because you are subscribed to
 the mailing list <linrad@xxxxxxxxxxxxxxxxxxxxx>.
To unsubscribe, E-mail to: <linrad-off@xxxxxxxxxxxxxxxxxxxxx>
To switch to the DIGEST mode, E-mail to <linrad-digest@xxxxxxxxxxxxxxxxxxxxx>
To switch to the INDEX mode, E-mail to <linrad-index@xxxxxxxxxxxxxxxxxxxxx>
Send administrative queries to  <linrad-request@xxxxxxxxxxxxxxxxxxxxx>


LINRADDARNIL