Richard wrote:
leif@xxxxxxxxxx wrote:Hi Richard,Ok untarred svgalib 1.9.24 in /src/so it compiled to pick upth makefile....NoDo not expect the Linrad fix to work for you unless you followthe instructions exactly. You have to untar in /usr/src/svgalib/ so it creates/usr/src/svgalib/svgalib-1.9.24/ where you type make svgalibbuilt linrad, loaded svgalib_helper, module in third party section of the kernel,.lsmod shows its thereYes, but you have to create device files too. Use make svgalib but change the file "svga" first 73 Leif OK I'll try it again Leif/r
Helper option set in /etc/vga/libvga.config , Thanks Roger Linrad starts or gets into its setup.. So once the mouse is running and the vga resolution is right I might see something works. So I can make comparisons between linrad and winrad Thanks guys Back to bed its just got light again Richard ############################################################# This message is sent to you because you are subscribed to the mailing list <linrad@xxxxxxxxxxxxxxxxxxxxx>. To unsubscribe, E-mail to: <linrad-off@xxxxxxxxxxxxxxxxxxxxx> To switch to the DIGEST mode, E-mail to <linrad-digest@xxxxxxxxxxxxxxxxxxxxx> To switch to the INDEX mode, E-mail to <linrad-index@xxxxxxxxxxxxxxxxxxxxx> Send administrative queries to <linrad-request@xxxxxxxxxxxxxxxxxxxxx>LINRADDARNIL