Re: [linrad] Install SVGALIB Problems

[Richard Hosking <richardh@xxxxxxxxxxxx>]

Stan
I had a fair bit of trouble with svgalib.
In the end I ignored a lot of errors and the so.1 libraries 
(libvga.so.1.4.3 and libvgagl.so.1.4.3) were present after compiling.
I ended up copying them to the relevant directory (/usr/lib I think) as 
ligvga.so.1 and libvgagl.so.1 and linrad would work after about 3 days 
of struggle!

In my quest to become more competent at programming I have been working 
through the Kdevelop and Qt Designer tutorials. These are better than 
ever as an IDE for development
Trolltech/Qt has an embedded version which is designed to run on cut 
down embedded Linux Platforms. This does not
use the X graphics server but rather uses direct graphics routines 
similar to svgalib.
To the programming experts - Could Linrad be easily adapted to use these?
If and when I get up to speed I would be willing to do some work on 
this. However it may well be a gigantic task.

Richard

Stan wrote:

> Hello the Net:
>
> Using SUSE 9.0 Pro, as root
>
> Flushed out the hard drive and reloaded all of the SUSe 9.0 Pro software
> KDE came up so I went to runlevel 3 in the /etc/inittab file to get 
> the command line.
> did UPDATEDB and LOCATE vgagl.h and got no response, so nothing to 
> remove.
>
> Went to install svgalib-1.4.3.tgz and proceed to make install without 
> error.
> upon make install I got multiple lines saying
> does not give a valid preprocessing token
> for
> HDisplay
> HSyncStart
> HSyncEnd
> HTotal
> VDisplay
> VSyncStart
> VSyncEnd
> VTotal
>
> Then:
>
> make [1]: ***[.depend.src] Error 1
> make [1]: Leaving directory '/usr/local/src/svgalib-1.4.3/sharedlib'
> make: ***[sharedlib/libvga.so.1.4.3] error 2
>
> Any suggestions on what to do to get svgalib working ?
>
> NASM installed OK. without error.
>
>
> Stan, WA1ECF
>
>
>
>
>
> zzzzzz
>
>
>
>
>
>
>
>
>
>
>
>
>



LINRADDARNIL