[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [linrad] RE: Newbie's first impressions



Having got LINRAD loaded and running I am at the point where I need 
some help with the soundcard situation.

I have a SB16 PnP (ISA) that I currently use successfully in Windows 
with WSJT etc.

soundconfig sees this sound card OK and configures it. However it 
routes the Line input through to the speaker. Consequently I am getting 
direct audio as well as filtered audio in LINRAD.

I started the KDE GUI and found the KMIX program. There I have the 
following 'channels':
VOL
BASS
TREBLE
SYNTH
PCM
SPEAKER
LINE
MIC
CD
MIX
IGAIN
OGAIN

If I mute LINE then the direct audio to the speaker stops, but I no 
longer get any input into LINRAD either.
(I set the recordable input to be LINE.)

What is the trick needed to get this going?

I also have another Soundcard plugged into a PCI slot but cannot enable 
that because of a lack of IRQ resources or something (when I try in 
Windows 98 hardware configuration). There is also built in audio which 
is enabled in Windows but sndconfig does not detect.

I'm beginning to remember why I shelved this project before now, but am 
determined to get it going now if I can.

Is there any way to access the mixer controls within LINRAD or from the 
terminal? - as having to quit LINRAD startx and muck around with KMIX 
each time I want to try another setting is slow and painful.

Many thanks

David




LINRADDARNIL
<