Re: Fedora, usleep and overrun errors.

[Patrick <f1ebk@xxxxxxx>]

> Did you by any chance enable memlockall ?
> 
> There is a bug in Fedora3 that causes a system crasch if you do.
> Read z_MLOC.txt
> 

No, I did not. In fact I already checked this and I got a system crash !

Linrad run OK under FC2. 
Like in FC3, a line containing mdev /dev/input/mice should be added to
the /etc/vga/libvga.config file.

I compiled all software as root (svgalib,nasm and linrad) as root.
libsvga doesn't work properly with ATI rage boards, I got segmentation
faults on a PII 400Mhz and with a K8 2Ghz... 

In order to resume my setup :
Mother board Abit KV8-MAX3
Processor AMD K8 3000+ (2Ghz)
Video : GEforce 2 MX100/200
Sound : On board VT8237 AC97 Audio controler

I am using (mostly) the parameters given by Roger in the W3SZ Linrad
Installation Data. Parameters limits are a little bit frantic here, so
I'll check them again. Sampling is made at 11Khz witch is far to much
for my SSB audio (6-8 Khz would be better).

Main spectrum and waterfall lives but I have a SELLIM Error so the other
areas are flat. No audio (yet) from the output.

Thanks for your help.

Very 73 

Patrick



#############################################################
This message is sent to you because you are subscribed to
  the mailing list <linrad@xxxxxxxxxxxxxxxxxxxxx>.
To unsubscribe, E-mail to: <linrad-off@xxxxxxxxxxxxxxxxxxxxx>
To switch to the DIGEST mode, E-mail to <linrad-digest@xxxxxxxxxxxxxxxxxxxxx>
To switch to the INDEX mode, E-mail to <linrad-index@xxxxxxxxxxxxxxxxxxxxx>
Send administrative queries to  <linrad-request@xxxxxxxxxxxxxxxxxxxxx>


LINRADDARNIL