[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

SV: [linrad] Homebrew Receivers, found links



Hi all, 
I also had to search a little to find working links, and here I found useful ones:
http://www.qsl.net/pa3ckr/hlmixer/index.html
http://www.warc.org.uk/cdg2000/The%20CDG2000%20Transceiver.htm

Best regards

Jan, SM4HFI

----- Ursprungligt meddelande ----- 
Från: "Dan Sawyer" <dansawyer@xxxxxxxxxxxxx>
Till: <linrad@xxxxxxxxxxxxxxxxxxxxxx>
Skickat: den 6 april 2003 17:16
Ämne: Re: [linrad] Homebrew Receivers


> All,
> 
> I am new to the concept of this radio and am having difficulty accessing 
> the information. Many of the links included lead to broken links. Are 
> they still available? Is there a good current starting point?
> 
> Thanks,
> Dan kb0qil
> 
> w3sz wrote:
> 
> > Hello all,
> >
> > Just a quick note to those who might be contemplating 'rolling their
> > own' front ends to use with LinRad.  The April RadCom Technical Topics 
> > by Pat Hawker G3VA features a variation by I7SWX on the H-mode mixer 
> > by G3SBI.  With these mixers IIP3's in excess of +40 dBm (up to +55 
> > dBm!!) are reported.
> >
> > These are, like the mixers Leif shows on his webpages, switching 
> > mixers.  What the differences are between the H-mode mixers and Leif's 
> > design (if any) I am not smart enough to see, except that the 
> > transformer configuration appears different with the H-mixers.
> >
> > These H-mode mixers mixers are also shown in the new ARRL Experimental 
> > Methods in RF Design book on pages 5.15 and 5.16, and used in a 
> > practical receiver on 6.48 and 6.49.  This reference describes this 
> > H-mode mixer design as 'perhaps the most exciting work published in 
> > the past decade in this area'.
> >
> > On the web they are discussed by PA3CKR at www.qsl.net/pa3ckr/himixer/
> >
> > The CDG2000 uses them www.warc.org.uk/cdg2000/introduction.htm
> >         Slightly off this topic, you might also have a look at the LO 
> > phase noise specs on that page for the CDG2000.
> >
> > There is an amusing rant on another list that complains that the 
> > writer was able to achieve an IP3 of 'only +40 dBm' with the H-mode 
> > mixer.  How sad ;)
> >
> > I'd appreciate any comments to the list by those who can comment on 
> > whether they have had experiences with these mixers, and to compare 
> > and contrast them with the switching mixers on Leif's pages.
> >
> > One interesting note is that PA3CKR built one version that used the 
> > Minicircuits T4-1 rather than a roll-your-own transformer and the 
> > FST3125, and that gave a respectible +41 dBm IIP3 (Input IP3).
> >
> > Thanks in advance,
> >
> > Roger Rehr
> > W3SZ
> >
> 
> 
LINRADDARNIL
g