Re: [linrad] linrad installation problem

[Henk <j.h.devries@xxxxxx>]

Terry, Arie,

Thanks for the reply.

The tar file is in the lir directorry and all decompressed files are there
as well.
I have given the command ./configure several times.

I can not find a makefile, so that's probably the cause of the problem.
However I can not figure out why the file is not generated.

Any ideas?

Henk


----- Original Message ----- 
From: "KJ7F" <terry@xxxxxxxxxxxxx>
To: <linrad@xxxxxxxxxxxxxxxxxxxxxx>
Sent: Sunday, May 18, 2003 9:02 PM
Subject: Re: [linrad] linrad installation problem


> Henk,
>
>     Just a guess, but did you place the tar file in a directory call "lir"
> and then give the command tar xvf lir0056.tar?   If you did this you will
> have a lir directory inside the lir directory that the tar file is in.
If
> this is the case you need to cd into the lir directory that has all the
> files and then follow Leif's instructions.
>
> Terry  KJ7F
>
> At 15:58 5/18/03 +0000, you wrote:
> >Maybe I am doing something wrong, but my linrad installation failed.
> >
> >Decompression of the lir00-56.tbz file in the lir directory is OK.
> >Next I gave the command ./configure (while in the lir dir)
> >This was executed as far as I can see, because I do not get any error
> >message in return.
> >
> >"make" gives the following message:
> >xxx no targets specified and no makefile found. Stop.
> >
> >What should I do, any help is welcome.
> >
> >Running Suse 8.0.
> >
> >73 Henk PA0CIS
> >
>

LINRADDARNIL