Re: [linrad] svgalib

[Matt KB0VUK <kb0vuk@xxxxxxxxxx>]

Svgalib is different from Xwindow (linux GUI).  Just because X works 
doesn't mean that linrad (or any program that uses svgalib to display 
graphics) will work.  I don't see RealTek 3105 listed as supported by 
svgalib-1.4.3.  It seems that svgalib is the factor most limiting linrad 
at this point, I.E. some (many?) people have configuration problems, some 
(much?) hardware isn't supported, but VESA mode usually helps.

73  Matt  KB0VUK

On Monday 02 June 2003 08:48, you wrote:
> Dr OM Alex,
> As far as I understand, svgalib deals with a card as it has been
> installed by linux. So at first you have to run linux with your card. If
> that goes well, I do not think svgalib is a problem as it allows you to
> set the video parameters according to what there has been installed.
> Arie
>
> ----- Original Message -----
> From: Alexander S. Yurkov <fitec@xxxxxxxxxxxx>
> To: <linrad@xxxxxxxxxxxxxxxxxxxxxx>
> Sent: Sunday, June 01, 2003 11:38 PM
> Subject: [linrad] svgalib
>
> > Does anybody know is it posible use svgalib-1.4.3 with my old svga
> > card 'RealTek 3105'. I need it for linrad running but can't
> > get G640x480x256 mode yet. Seems there is no driver for such a
> > card...:-(
> >
> >
> > 73 de RA9MB/Alex

LINRADDARNIL